simchair4:guide_collective_head_b407
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
simchair4:guide_collective_head_b407 [2021/03/28 23:54] hc625ma |
simchair4:guide_collective_head_b407 [2021/04/05 00:19] (current) hc625ma |
||
|---|---|---|---|
| Line 25: | Line 25: | ||
| ===== Repository path ===== | ===== Repository path ===== | ||
| - | simchair4_models\printable components\peripherals\helicopter\collective lever\c_switch panels\b407 | + | Files for this collective head are distributed for a humble fee to support further development of the project. Please consult with the [[simchair4: |
| + | |||
| + | ===== Features ===== | ||
| + | |||
| + | This is a semi-scale head with the following features: | ||
| + | |||
| + | * 2 3-way switches with middle buttons support (3 joystick buttons each) | ||
| + | * 4 buttons with mode switch support (12 joystick buttons) | ||
| + | * physical hat switch respects mode switch position and is mapped to 3 virtual hat switches | ||
| + | * this head is intended to use with levers with a 206-style lever body and a physical throttle latch | ||
| ===== Assembly manual ===== | ===== Assembly manual ===== | ||
| - | 1. Solder wires to the hat switch. The ground wire is the top-left (black) wire. Note how it's slightly closer from the center pin than the other one. Check that every direction of the hat works with a multimeter, connect it between the GND pin and each of the other pins. | + | 1. Solder wires to the hat switch. The ground wire is the top-left (black) wire. **Note how it's slightly closer from the center pin than the other one**. Check that every direction of the hat works with a multimeter, connect it between the GND pin and each of the other pins. |
| {{: | {{: | ||
| Line 53: | Line 62: | ||
| | ETH SOCKET PIN 7 | DTR | | | ETH SOCKET PIN 7 | DTR | | ||
| + | 5. Fix everything with hot glue. Put the Pro Mini board into thermal shrink tube or wrap with duct tape. Add some cable ties where needed to organize cables carefully. | ||
| + | |||
| + | {{: | ||
| + | |||
| + | 6. Upload the firmware to the board, using the master controller set to " | ||
| + | |||
| + | #define B407_COLL_SWITCH_PANEL | ||
| + | | ||
| + | in master firmware, re-flash your master, and enjoy flying! | ||
simchair4/guide_collective_head_b407.1616968460.txt.gz · Last modified: 2021/03/28 23:54 by hc625ma
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: GNU Free Documentation License 1.3
