simchair4:guide_cyclic_base
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
simchair4:guide_cyclic_base [2020/02/08 20:57] hc625ma |
simchair4:guide_cyclic_base [2021/01/07 10:25] (current) hc625ma |
||
|---|---|---|---|
| Line 19: | Line 19: | ||
| * 2 x SS495A1 Hall effect sensors | * 2 x SS495A1 Hall effect sensors | ||
| + | * 1 x ADS1115 ADC board | ||
| * 2x 6x6x4mm magnets | * 2x 6x6x4mm magnets | ||
| * 4x M8x60mm bols | * 4x M8x60mm bols | ||
| Line 25: | Line 26: | ||
| * 4x M8x140mm bolts | * 4x M8x140mm bolts | ||
| * 32x M8 regular washers | * 32x M8 regular washers | ||
| - | * 4x M8 reinforced | + | * 4x M8 fender |
| * 14x M8 spring washers | * 14x M8 spring washers | ||
| * 34x M8 nuts | * 34x M8 nuts | ||
| Line 32: | Line 33: | ||
| * 1x M6x80mm HEX(!) bolt | * 1x M6x80mm HEX(!) bolt | ||
| * 2x M6 regular washers | * 2x M6 regular washers | ||
| - | * 4x M6 reinforced | + | * 4x M6 fender |
| * 4x M6 nuts | * 4x M6 nuts | ||
| * 24x M4x40mm screws | * 24x M4x40mm screws | ||
simchair4/guide_cyclic_base.1581191856.txt.gz ยท Last modified: 2020/02/08 20:57 by hc625ma
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: GNU Free Documentation License 1.3
