simchair4_collective_base
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
simchair4_collective_base [2019/09/14 22:27] hc625ma [Simchair MKIV collective lever base] |
— (current) | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | =======Simchair MKIV collective lever base======= | ||
| - | \\ | ||
| - | {{ http:// | ||
| - | \\ | ||
| - | |||
| - | {{ http:// | ||
| - | |||
| - | ====Components==== | ||
| - | |||
| - | * 1 x 10x10mm aluminum square pipe | ||
| - | * 1 x 20×10 aluminum rectangular pipe for chair mounting (the mount for the IKEA GUNDE chair is included) | ||
| - | * 1 x SS495A1 hall sensor | ||
| - | * 1 x MTS-103 ON-OFF-ON switch | ||
| - | * 1 x 16K1 10KOhm LINEAR rotary [[https:// | ||
| - | * 1 x 6x6x4mm square magnet | ||
| - | * 1 x M6x70mm screw | ||
| - | * 2 x M6 washers (reinforced) | ||
| - | * 1 x M6 nut | ||
| - | * 2 x M6x18x8mm hubs | ||
| - | * 6 x M4x40mm screws | ||
| - | * 4 x M4x70mm screws | ||
| - | * 1 x M3x20mm screw | ||
| - | * 1 x M3 nyloc nut | ||
| - | * 4 x M4 nyloc nuts | ||
| - | * 4 x M3x50mm screws for tensioner halves contraction | ||
| - | * 4 x M8x70 bolts | ||
| - | * 4 x M8x75mm bolts | ||
| - | * 8 x M8 nuts | ||
| - | * 10 x M8 washers (regular, non-reinforced) | ||
| - | * 4 x M8 spring washers | ||
| - | * 1 x bag of M4 nuts | ||
| - | * 4 x 608 bearings (standard skateboard bearings) | ||
| - | * 1 x Arduino Pro mini | ||
| - | * 1 x Simchair MKIV Master controller | ||
| - | * super glue (cyanoacrylate), | ||
| - | |||
| - | ====Files location in repos==== | ||
| - | |||
| - | simchair4_models\printable components\peripherals\helicopter\collective lever\a_base | ||
| - | simchair4_software\peripherals - choose preferred variant of the lever | ||
| - | |||
| - | |||
| - | |||
simchair4_collective_base.1568492870.txt.gz · Last modified: 2019/09/14 22:27 by hc625ma
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: GNU Free Documentation License 1.3
