This is an old revision of the document!

Simchair MKIV EVO USB collective lever base

1 x 10x10mm aluminum square pipe (200mm length for single throttle)
1 x SS495A1 hall sensor
2 x MTS-103 ON-OFF-ON switch
1 x 6x6x4mm square magnet (or 5x5x5mm)
1 x M6x70mm screw
2 x M6 fender washers (sometimes called reinforced washers)
1 x M6 nut
2 x M6x18x8mm hubs
6 x M4x40mm screws
6 x M4x70mm screws (2 of them for securing devices that go into the slot on top)
1 x M3x20mm screw (round head)
1 x M3 nyloc nut
4 x M4 nyloc nuts
4 x M3x50mm screws for tensioner halves contraction
4 x M8x70 bolts
4 x M8x75mm bolts
8 x M8 nuts
10 x M8 washers (regular)
4 x M8 spring washers
1 x bag of M4 nuts
4 x 608 bearings (standard skateboard bearings)
1 x Arduino Pro micro
super glue (cyanoacrylate), hot glue gun

simchair4_models\printable components\peripherals\helicopter\collective lever\a_base\ac_base_evo_usb - models

Please follow the assembly guide for the classic base up to the point of wiring things. From there. please follow the table below:

CONN POINT A	CONN POINT B
MODE SW LEFT BOTTOM PIN	Pro Micro PIN 4
MODE SW LEFT MIDDLE PIN	Pro Micro GND
MODE SW LEFT BOTTOM PIN	Pro Micro PIN 5
MODE SW RIGHT TOP PIN	Pro Micro PIN 6
MODE SW RIGHT MIDDLE PIN	Pro Micro GND
MODE SW RIGHT BOTTOM PIN	Pro Micro PIN 7
SS495A1 VCC	VCC CABLE JOINT
SS495A1 GND	GND CABLE JOINT
SS495A1 SIGNAL	Pro Micro PIN A0
THR POT LEFT (looking from the back)	VCC CABLE JOINT
THR POT RIGHT	GND CABLE JOINT
THR POT MIDDLE	Pro Micro PIN A1
I2C RIBBON VCC	VCC CABLE JOINT
I2C RIBBON GND	GND CABLE JOINT
I2C RIBBON SDA	Pro Micro PIN 2
I2C RIBBON SCL	Pro Micro PIN 3
VCC CABLE JOINT	Pro Micro PIN VCC
GND CABLE JOINT	Pro Micro PIN GND

Simchair MKIV wiki