This is a semi-scale Bell 407 style head. This version is modeled after the 407GXP switch panel, as it has more buttons on it than others. From what I've seen, there are a lot of variants of this head with different buttons on it. Proportions should be accurate, with some minimal deviation needed to adapt the head to the existing simchair MKIV collective lever body with a physical latch.

• 1 x KN3(B)-101AP-A1 ON-OFF switch
• 2 x KN3(B)-103A-A3 ON-OFF-ON switch
• 1 x KN3(B)-223 switch
• 1 x PBS-10B2 button
• 1 x PBS-16B button
• 1 x SAC-01 switch cover
• 1 x 12x12x5mm tact button (or similar height)
• 1 x 10mm 5-way hat switch (https://cutt.ly/BxZti0f)
• 9 x M3x50mm round screws and nuts
• 1 x M3x40mm round head screw and nut
• 1 x Arduino Pro Mini
• 1 x TJ8P8C Ethernet socket (12,5x15x17,6mm)

simchair4_models\printable components\peripherals\helicopter\collective lever\c_switch panels\b407 collective head

1. Solder wires to the hat switch. The ground wire is the top-left (black) wire. Note how it's slightly closer from the center pin than the other one. Check that every direction of the hat works with a multimeter, connect it between the GND pin and each of the other pins.

2. Put the head onto the lever and drill the hole on the side for the bolt that holds the head on the lever. Put the nut into the socket on the other side after it's done.

3. Insert switches and solder wires as shown in the picture below: