simchair4:guide_collective_base_evo_usb
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
simchair4:guide_collective_base_evo_usb [2021/03/14 23:16] hc625ma |
simchair4:guide_collective_base_evo_usb [2022/05/30 00:59] (current) hc625ma |
||
|---|---|---|---|
| Line 31: | Line 31: | ||
| ==== Repository path ==== | ==== Repository path ==== | ||
| - | simchair4_models\printable components\peripherals\helicopter\collective lever\a_base\ac_base_evo_usb - models \\ | + | simchair4_models\printable components\peripherals\helicopter\collective lever\a_base\ |
| + | |||
| + | please use [[https:// | ||
| ==== Features ==== | ==== Features ==== | ||
| - | If you already have your nice sim pit setup you don't want to change, and just need a solid collective lever to complete it, this is your choice. This version here does not have the top extension slot, if you want it, just take the enclosure part from the regular | + | If you already have your nice sim pit setup you don't want to change, and just need a solid collective lever to complete it, this is your choice. This version here does not have the top extension slot, if you want it, just take the enclosure part from the i2c EVO version, and route the ethernet cable between the base and the extension inside of the base box. |
| This lever has the following functions: | This lever has the following functions: | ||
| Line 45: | Line 48: | ||
| * axis switching: this lever can drive 2 throttle axes with 1 physical throttle grip. The right mode switch controls which axis is assigned to the throttle pot at the moment. When you flip the switch, you need to reach the position of your other axis before it will start moving, to avoid sudden axis value bumps and having to remember what is where. | * axis switching: this lever can drive 2 throttle axes with 1 physical throttle grip. The right mode switch controls which axis is assigned to the throttle pot at the moment. When you flip the switch, you need to reach the position of your other axis before it will start moving, to avoid sudden axis value bumps and having to remember what is where. | ||
| - | IMPORTANT: TO INITIALIZE THROTTLE AXES, FLIP THE THR MODE SWITCH | + | IMPORTANT: |
| ==== Assembly Guide ==== | ==== Assembly Guide ==== | ||
| - | Please follow the assembly guide for the classic base up to the point of wiring things. From there. please follow the table below: | + | Please follow the assembly guide for the classic base up to the point of wiring things. From there, please |
| + | |||
| + | {{: | ||
| + | |||
| + | To make soldering the USB-B socket easier, cut some part of each wire of the ribbon cable on the Arduino side, making it thinner. After soldering, carefully check that the board is detected by your PC and can be flashed, and pour some hot glue onto the board to fix soldered wires. After it cools down, check the board again, if it works, go ahead with the rest of the wiring process. | ||
| ^ CONN POINT A ^ CONN POINT B ^ | ^ CONN POINT A ^ CONN POINT B ^ | ||
simchair4/guide_collective_base_evo_usb.1615760189.txt.gz · Last modified: 2021/03/14 23:16 by hc625ma
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: GNU Free Documentation License 1.3
