This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
simchair4:guide_collective_base_evo_usb [2021/03/31 09:50] hc625ma |
simchair4:guide_collective_base_evo_usb [2022/05/30 00:59] (current) hc625ma |
||
---|---|---|---|
Line 31: | Line 31: | ||
==== Repository path ==== | ==== Repository path ==== | ||
- | simchair4_models\printable components\peripherals\helicopter\collective lever\a_base\ac_base_evo_usb - models \\ | + | simchair4_models\printable components\peripherals\helicopter\collective lever\a_base\ |
+ | |||
+ | please use [[https:// | ||
==== Features ==== | ==== Features ==== | ||
Line 49: | Line 52: | ||
==== Assembly Guide ==== | ==== Assembly Guide ==== | ||
- | Please follow the assembly guide for the classic base up to the point of wiring things. From there, please solder the USB-B socket to the Pro Micro board as shown in the picture below, and then follow the connections table: | + | Please follow the assembly guide for the classic base up to the point of wiring things. From there, please solder the USB-B socket to a cut micro-USB cable (look at the colors of wires in the picture below, the socket on the pic is facing us), insert it into a Pro Micro board, and then follow the connections table: |
- | {{http:// | + | {{:simchair4: |
To make soldering the USB-B socket easier, cut some part of each wire of the ribbon cable on the Arduino side, making it thinner. After soldering, carefully check that the board is detected by your PC and can be flashed, and pour some hot glue onto the board to fix soldered wires. After it cools down, check the board again, if it works, go ahead with the rest of the wiring process. | To make soldering the USB-B socket easier, cut some part of each wire of the ribbon cable on the Arduino side, making it thinner. After soldering, carefully check that the board is detected by your PC and can be flashed, and pour some hot glue onto the board to fix soldered wires. After it cools down, check the board again, if it works, go ahead with the rest of the wiring process. |