This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
simchair4:guide_collective_body_twin-throttle [2019/09/22 15:26] hc625ma |
simchair4:guide_collective_body_twin-throttle [2020/03/20 21:54] (current) hc625ma |
||
---|---|---|---|
Line 1: | Line 1: | ||
=======Simchair MKIV collective twin throttle lever body with tactile mark detents======= | =======Simchair MKIV collective twin throttle lever body with tactile mark detents======= | ||
- | This manual describes the process of building a twin throttle lever body, with interchangeable heads, and a physical idle-stop detent latch. This manual was ported from the MKIII version, so you will see the MKIII collective base in the pictures: please | + | This manual describes the process of building a twin throttle lever body, with interchangeable heads, and a physical idle-stop detent latch. This manual was ported from the MKIII version, so you will see the MKIII collective base in the pictures. (Please |
+ | |||
+ | {{http:// | ||
====Components==== | ====Components==== | ||
Line 7: | Line 9: | ||
* 1 x 200x10x10mm aluminum square pipe | * 1 x 200x10x10mm aluminum square pipe | ||
* 1 x 105x10x10mm aluminum square pipe | * 1 x 105x10x10mm aluminum square pipe | ||
- | * 6 x M3x30mm screws and nuts | + | * 8 x M3x30mm screws and nuts |
* 1 x M3 x 35mm screw and a nut | * 1 x M3 x 35mm screw and a nut | ||
- | * 1 x M4x80 bolts | + | * 2 x M4x80 bolts |
- | * 1 x PBS-16B button | + | * 2 x 16K1 linear 10K pots |
Line 19: | Line 21: | ||
==== Assembly highlights ==== | ==== Assembly highlights ==== | ||
- | none | + | None. |
==== Assembly Guide ==== | ==== Assembly Guide ==== | ||
Line 110: | Line 112: | ||
{{http:// | {{http:// | ||
- | 25. Put the I2C cable housing onto the lever. Use an M3x35mm screw, and secure it, in its place. | + | 25. Put the I2C cable housing onto the lever. |
26. Solder the cables to your Arduino Pro Mini board, as follows: | 26. Solder the cables to your Arduino Pro Mini board, as follows: | ||
Line 121: | Line 123: | ||
I2C HEAD CABLE SDA -> PRO MINI PIN A4 | I2C HEAD CABLE SDA -> PRO MINI PIN A4 | ||
- | 27. Put the lid onto the housing and secure with 4 M8x70mm screws. | + | 27. Put the lid onto the housing, and secure |
{{http:// | {{http:// | ||
- | 28. Make sure all the cables fit snugly inside the enclosure, and nothing touches the magnet: | + | 28. Please check that all of the cables fit snugly inside the enclosure, and nothing touches the magnet. |
Then you can close the hatch. | Then you can close the hatch. | ||