Differences

This shows you the differences between two versions of the page.

--- simchair4:guide_collective_body_twin-throttle [2019/09/22 15:29]
hc625ma
+++ simchair4:guide_collective_body_twin-throttle [2020/03/20 21:54] (current)
hc625ma
@@ Line 1: / Line 1: @@
 =======Simchair MKIV collective twin throttle lever body with tactile mark detents=======
-This manual describes the process of building a twin throttle lever body, with interchangeable heads, and a physical idle-stop detent latch. This manual was ported from the MKIII version, so you will see the MKIII collective base in the pictures: please ignore this.
+This manual describes the process of building a twin throttle lever body, with interchangeable heads, and a physical idle-stop detent latch. This manual was ported from the MKIII version, so you will see the MKIII collective base in the pictures. (Please ignore this).
 {{http://hc625ma.org/wp-content/uploads/2018/12/IMG_20181202_215744-e1544001291605.jpg?300}}
@@ Line 21: / Line 21: @@
 ==== Assembly highlights ====
-none
+None.
 ==== Assembly Guide ====
@@ Line 112: / Line 112: @@
 {{http://hc625ma.org/wp-content/uploads/2019/04/15541547885343836952077109516302.jpg?300}}
-. Put the I2C cable housing onto the lever. Use an M3x35mm screw, and secure it, in its place.
+. Put the I2C cable housing onto the lever.
 . Solder the cables to your Arduino Pro Mini board, as follows:
@@ Line 123: / Line 123: @@
     I2C HEAD CABLE SDA                   -> PRO MINI PIN A4
-. Put the lid onto the housing and secure with 4 M8x70mm screws.
+. Put the lid onto the housing, and secure it with 4 M8x70mm screws.
 {{http://hc625ma.org/wp-content/uploads/2019/04/15542139378672177653029232012817.jpg?300}}
-. Make sure all the cables fit snugly inside the enclosure, and nothing touches the magnet:
+. Please check that all of the cables fit snugly inside the enclosure, and nothing touches the magnet.
 Then you can close the hatch.

Simchair MKIV wiki

User Tools

Site Tools

Differences

Page Tools