simchair4_collective_base
This is an old revision of the document!
Simchair MKIV collective lever base
Components
- 1 x 10x10mm aluminum square pipe
- 1 x 20×10 aluminum rectangular pipe for chair mounting (the mount for the IKEA GUNDE chair is included)
- 1 x SS495A1 hall sensor
- 1 x MTS-103 ON-OFF-ON switch
- 1 x 16K1 10KOhm LINEAR rotary potentiometer
- 1 x 6x6x4mm square magnet
- 1 x M6x70mm screw
- 2 x M6 washers (reinforced)
- 1 x M6 nut
- 2 x M6x18x8mm hubs
- 6 x M4x40mm screws
- 4 x M4x70mm screws
- 1 x M3x20mm screw
- 1 x M3 nyloc nut
- 4 x M4 nyloc nuts
- 4 x M3x50mm screws for tensioner halves contraction
- 4 x M8x70 bolts
- 4 x M8x75mm bolts
- 8 x M8 nuts
- 10 x M8 washers (regular, non-reinforced)
- 4 x M8 spring washers
- 1 x bag of M4 nuts
- 4 x 608 bearings (standard skateboard bearings)
- 1 x Arduino Pro mini
- 1 x Simchair MKIV Master controller
- super glue (cyanoacrylate), hot glue gun
simchair4_collective_base.1568492552.txt.gz · Last modified: 2019/09/14 22:22 by hc625ma
Except where otherwise noted, content on this wiki is licensed under the following license: GNU Free Documentation License 1.3
