simchair4:guide_collective_head_b206
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
simchair4:guide_collective_head_b206 [2019/10/15 00:07] hc625ma |
simchair4:guide_collective_head_b206 [2019/11/02 21:21] (current) rfvizarra [Components] |
||
|---|---|---|---|
| Line 14: | Line 14: | ||
| * 1 x PBS-10B2 button | * 1 x PBS-10B2 button | ||
| * 3 x M3x40mm countersunk screws and nuts | * 3 x M3x40mm countersunk screws and nuts | ||
| + | * 1 x M3x35mm round head screw and nut | ||
| * 1 x Arduino Pro Mini | * 1 x Arduino Pro Mini | ||
| + | * 1 x TJ8P8C Ethernet sockets (12, | ||
| ===== Repository path ===== | ===== Repository path ===== | ||
| Line 23: | Line 25: | ||
| * print small parts at the highest quality setting and 0,1mm layer height | * print small parts at the highest quality setting and 0,1mm layer height | ||
| - | * if you want the version of the panel with letters - print it at 0,1mm as well, adjust the number of layers on top to 5 or 6 | + | * if you want the version of the panel with letters - print it at 0,1mm as well, adjust the number of layers on top to 5 or 6; use layer width equal the width of your nozzle! |
| * use a correction white marker to fill letters with white paint, and then carefully paint them over with a black permanent marker (it won't be filling letters!), then paint the rest of the panel with it for colors to match. | * use a correction white marker to fill letters with white paint, and then carefully paint them over with a black permanent marker (it won't be filling letters!), then paint the rest of the panel with it for colors to match. | ||
| Line 68: | Line 70: | ||
| 5. Flash the head with its firmware, uncomment it in the " | 5. Flash the head with its firmware, uncomment it in the " | ||
| - | 6. Put everything into the box, do some cable management so that the aluminum pipe won't damage wires when the head will be put onto the lever. | + | 6. Put everything into the box, do some cable management so that the aluminum pipe won't damage wires when the head will be put onto the lever. Push onto the Ethernet socket so it will protrude slightly from the bottom. Glue the socket cap part with some cyanoacrylate and level the socket with it so it will look good. Carefully fix the socket in place with hot glue. |
| + | {{: | ||
| + | {{: | ||
| + | {{: | ||
| {{: | {{: | ||
| {{: | {{: | ||
simchair4/guide_collective_head_b206.1571090876.txt.gz · Last modified: 2019/10/15 00:07 by hc625ma
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: GNU Free Documentation License 1.3
