Differences

This shows you the differences between two versions of the page.

--- simchair4:guide_collective_head_b206 [2019/10/15 14:49]
hc625ma
+++ simchair4:guide_collective_head_b206 [2019/11/02 21:21] (current)
rfvizarra [Components]
@@ Line 16: / Line 16: @@
   * 1 x M3x35mm round head screw and nut
   * 1 x Arduino Pro Mini
+  * 1 x TJ8P8C Ethernet sockets (12,5x15x17,6mm)
 ===== Repository path =====
@@ Line 69: / Line 70: @@
 . Flash the head with its firmware, uncomment it in the "device definitions" tab in master controller firmware and check if everything works.
-. Put everything into the box, do some cable management so that the aluminum pipe won't damage wires when the head will be put onto the lever.
+. Put everything into the box, do some cable management so that the aluminum pipe won't damage wires when the head will be put onto the lever. Push onto the Ethernet socket so it will protrude slightly from the bottom. Glue the socket cap part with some cyanoacrylate and level the socket with it so it will look good. Carefully fix the socket in place with hot glue.
+{{:simchair4:img_20191019_225206.jpg?direct&400|}}
+{{:simchair4:img_20191019_225301.jpg?direct&400|}}
+{{:simchair4:img_20191019_225743.jpg?direct&400|}}
 {{:simchair4:15710892381475478172839000609674.jpg?direct&400|}}
 {{:simchair4:15710893480676084077604676264595.jpg?direct&400|}}

Simchair MKIV wiki