Simchair MKIV wiki

User Tools

Site Tools

Trace: • guide_collective_head_simple_se
simchair4:guide_collective_head_simple_se

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
simchair4:guide_collective_head_simple_se [2021/04/05 00:53]
hc625ma 		simchair4:guide_collective_head_simple_se [2021/04/06 02:43] (current)
hc625ma
Line 25: Line 25:
 ==== Assembly Guide ==== ==== Assembly Guide ====
  
-1. Assemble collective base up to the point shown on the pic below (look at the [[simchair4:guide_collective_body_single-throttle-for-integrated-heads|Single throttle lever body for integrated heads]] manual but use parts from the simple collective SE body directory instead). Note that instead of the 4-wire I2C cable used in a regular lever, a 6-wire hat switch cable is inserted. Note the colors of the cable, the hat switch cable is strictly color-coded for ease of use.+1. Assemble collective base and the lever body up to the point shown on the pic below (look at the [[simchair4:guide_collective_body_single-throttle-for-integrated-heads|Single throttle lever body for integrated heads]] manual but use parts from the simple collective SE body directory instead). Note that instead of the 4-wire I2C cable used in a regular lever, a 6-wire hat switch cable is inserted. Note the colors of the cable, the hat switch cable is strictly color-coded for ease of use.
  
 {{:simchair4:img_20210404_232457.jpg?direct&300|}} {{:simchair4:img_20210404_232457.jpg?direct&300|}}
Line 69: Line 69:
 | HATSW WHITE | ARDUINO PIN 12 | | HATSW WHITE | ARDUINO PIN 12 |
  
-7. Flash the lever with firmware for your chosen variant (I2C or USB) and calibrate it. (Please consult with this video on YouTube if you're not familiar with the process). The video is for the single collective, but for this one, the process is the same minus the name of the lever.+7. **ENCLOSURE WITH EXTENSION SLOT ONLY** 
 +If you've chosen to make a lever with the base extension slot, solder the 4-wire i2c cable as shown in the picture below. You can solder it directly to your base extension of choice, or add an RJ-45 plug so you can connect stuff easily later. 
 + 
 +^ CONN POINT A      ^ CONN POINT B ^   
 +| I2C VCC | VCC CABLE JOINT | 
 +| I2C GND | VCC CABLE JOINT | 
 +| I2C SCL | PRO MICRO PIN 3 | 
 +| I2C SDA | PRO MICRO PIN 2 | 
 + 
 +8. Flash the lever with firmware for your chosen variant (I2C or USB) and calibrate it. (Please consult with this video on YouTube if you're not familiar with the process). The video is for the single collective, but for this one, the process is the same minus the name of the lever.
  
 That's it! Enjoy flying =) That's it! Enjoy flying =)
  
simchair4/guide_collective_head_simple_se.1617576811.txt.gz · Last modified: 2021/04/05 00:53 by hc625ma

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: GNU Free Documentation License 1.3
GNU Free Documentation License 1.3 Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki