simchair4:guide_collective_head_simple_se
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
simchair4:guide_collective_head_simple_se [2021/04/05 00:54] hc625ma |
simchair4:guide_collective_head_simple_se [2021/04/06 02:43] (current) hc625ma |
||
|---|---|---|---|
| Line 69: | Line 69: | ||
| | HATSW WHITE | ARDUINO PIN 12 | | | HATSW WHITE | ARDUINO PIN 12 | | ||
| - | 7. Flash the lever with firmware for your chosen variant (I2C or USB) and calibrate it. (Please consult with this video on YouTube if you're not familiar with the process). The video is for the single collective, but for this one, the process is the same minus the name of the lever. | + | 7. **ENCLOSURE WITH EXTENSION SLOT ONLY** |
| + | If you've chosen to make a lever with the base extension slot, solder the 4-wire i2c cable as shown in the picture below. You can solder it directly to your base extension of choice, or add an RJ-45 plug so you can connect stuff easily later. | ||
| + | |||
| + | ^ CONN POINT A ^ CONN POINT B ^ | ||
| + | | I2C VCC | VCC CABLE JOINT | | ||
| + | | I2C GND | VCC CABLE JOINT | | ||
| + | | I2C SCL | PRO MICRO PIN 3 | | ||
| + | | I2C SDA | PRO MICRO PIN 2 | | ||
| + | |||
| + | 8. Flash the lever with firmware for your chosen variant (I2C or USB) and calibrate it. (Please consult with this video on YouTube if you're not familiar with the process). The video is for the single collective, but for this one, the process is the same minus the name of the lever. | ||
| That's it! Enjoy flying =) | That's it! Enjoy flying =) | ||
simchair4/guide_collective_head_simple_se.1617576874.txt.gz · Last modified: 2021/04/05 00:54 by hc625ma
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: GNU Free Documentation License 1.3
