User Tools

Site Tools


simchair4:guide_collective_head_simple_se

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
simchair4:guide_collective_head_simple_se [2021/04/05 20:45]
hc625ma
simchair4:guide_collective_head_simple_se [2021/04/06 02:43] (current)
hc625ma
Line 71: Line 71:
 7. **ENCLOSURE WITH EXTENSION SLOT ONLY** 7. **ENCLOSURE WITH EXTENSION SLOT ONLY**
 If you've chosen to make a lever with the base extension slot, solder the 4-wire i2c cable as shown in the picture below. You can solder it directly to your base extension of choice, or add an RJ-45 plug so you can connect stuff easily later. If you've chosen to make a lever with the base extension slot, solder the 4-wire i2c cable as shown in the picture below. You can solder it directly to your base extension of choice, or add an RJ-45 plug so you can connect stuff easily later.
- 
  
 ^ CONN POINT A      ^ CONN POINT B ^   ^ CONN POINT A      ^ CONN POINT B ^  
Line 78: Line 77:
 | I2C SCL | PRO MICRO PIN 3 | | I2C SCL | PRO MICRO PIN 3 |
 | I2C SDA | PRO MICRO PIN 2 | | I2C SDA | PRO MICRO PIN 2 |
-| I2C VCC | WHITE-ORANGE WIRE RJ-45 | 
-| I2C GND | ORANGE WIRE RJ-45 | 
-| I2C SCL | WHITE-GREEN WIRE RJ-45| 
-| I2C SDA | BLUE WIRE RJ-45 | 
- 
  
-7. Flash the lever with firmware for your chosen variant (I2C or USB) and calibrate it. (Please consult with this video on YouTube if you're not familiar with the process). The video is for the single collective, but for this one, the process is the same minus the name of the lever.+8. Flash the lever with firmware for your chosen variant (I2C or USB) and calibrate it. (Please consult with this video on YouTube if you're not familiar with the process). The video is for the single collective, but for this one, the process is the same minus the name of the lever.
  
 That's it! Enjoy flying =) That's it! Enjoy flying =)
  
simchair4/guide_collective_head_simple_se.1617648320.txt.gz · Last modified: 2021/04/05 20:45 by hc625ma