This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
simchair4:guide_collective_head_uh-1 [2019/09/21 22:50] retrogamer |
simchair4:guide_collective_head_uh-1 [2024/03/30 08:44] (current) retrogamer addition |
||
---|---|---|---|
Line 76: | Line 76: | ||
6. Cut a 12-wire cable off the ribbon. Solder wires one by one, following numbers on the picture. The last wire will be the ground one. Use the same contact pads row, where the ground wire is. | 6. Cut a 12-wire cable off the ribbon. Solder wires one by one, following numbers on the picture. The last wire will be the ground one. Use the same contact pads row, where the ground wire is. | ||
- | \\ {{http:// | + | \\ {{:simchair4: |
---- | ---- | ||
Line 107: | Line 107: | ||
---- | ---- | ||
- | 12. Solder 4-wire cable to 1st 4 pins of an Ethernet socket. | + | 12. Solder |
\\ {{http:// | \\ {{http:// | ||
Line 113: | Line 113: | ||
13. Press-fit the socket into its slot and check that wires are still connected to the socket with a multimeter. | 13. Press-fit the socket into its slot and check that wires are still connected to the socket with a multimeter. | ||
+ | |||
+ | To make the installation easier: | ||
+ | |||
+ | - Make sure the pins and cables are bent rather flat, so that you have the clearance to slide the socket to its place from the inside. | ||
+ | |||
+ | - Use a screwdriver or similar to apply force and push the socket thru the opening, in the end. | ||
+ | |||
+ | - Applying the hot glue might get tricky, as the crevice is small, use of a tool might be a good idea. | ||
+ | |||
\\ {{http:// | \\ {{http:// | ||
{{http:// | {{http:// | ||
Line 138: | Line 147: | ||
* SOCKET PIN3 -> SCL (A5) | * SOCKET PIN3 -> SCL (A5) | ||
* SOCKET PIN4 -> SDA (A4) | * SOCKET PIN4 -> SDA (A4) | ||
+ | * SOCKET PIN5 -> Rx | ||
+ | * SOCKET PIN6 -> Tx | ||
+ | * SOCKET PIN7 -> DTR | ||
\\ {{http:// | \\ {{http:// | ||