This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
simchair4:guide_collective_pedestal_simple [2019/09/21 21:14] retrogamer [About Pedestals] |
simchair4:guide_collective_pedestal_simple [2020/02/12 21:18] (current) hc625ma |
||
---|---|---|---|
Line 2: | Line 2: | ||
===== About Pedestals ===== | ===== About Pedestals ===== | ||
- | A pedestal is a device that is mounted onto the collective base to extend its functionality. A few of them are currently available under the MKIV line of hardware. \\ The recommended default option for flying in VR is a simple pedestal. If you use radios often, please try this one instead: [[http:// | + | A pedestal is a device that is mounted onto the collective base to extend its functionality. A few of them are currently available under the MKIV line of hardware. \\ The recommended default option for flying in VR, is the simple pedestal. If you use radios often, please try this one instead: [[http:// |
\\ {{http:// | \\ {{http:// | ||
===== Summary ===== | ===== Summary ===== | ||
- | The Simple Pedestal for the MKIV collective base is a universal VR mouse replacement device, that will make your flying experience much better in a simple way. \\ It features a single **knob emulating the mousewheel** and a **ministick to control | + | The Simple Pedestal for the MKIV collective base is a universal VR mouse replacement device. |
+ | It will make your flying experience much better in a simple way. \\ It features a single **knob, emulating the mousewheel** and a **ministick, to control | ||
- | I’ve tried it, and i can say that seriously, this thing is simply epic, and is definitely one of the highlights of the MKIV line. \\ {{http:// | + | I’ve tried it, and i can say that seriously, this thing is simply epic, and it is definitely one of the highlights of the MKIV line. \\ {{http:// |
{{http:// | {{http:// | ||
Line 18: | Line 19: | ||
* 1 x PEC16-4220F-S0024 encoder | * 1 x PEC16-4220F-S0024 encoder | ||
* 2 x PBS-10B2 buttons | * 2 x PBS-10B2 buttons | ||
+ | * 1 x 6x6x5mm tact button | ||
* 1 x KY-023 ministick board | * 1 x KY-023 ministick board | ||
* 1 x Bourns PTD901-2015K-B103 10K resistor | * 1 x Bourns PTD901-2015K-B103 10K resistor | ||
* 1 x TJ8P8C Ethernet socket | * 1 x TJ8P8C Ethernet socket | ||
* 4 x M3x35mm screws and nuts | * 4 x M3x35mm screws and nuts | ||
+ | * 4 x M3x10m screws to fix the KY board | ||
* 1 x Arduino Pro Mini | * 1 x Arduino Pro Mini | ||
Line 72: | Line 75: | ||
---- | ---- | ||
- | 7. Solder the ground wire to all switches and buttons, including the encoder. | + | 7. Solder the ground wire to all switches and buttons, including |
\\ {{http:// | \\ {{http:// | ||
{{http:// | {{http:// |