This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
simchair4:guide_master_controller_v2 [2020/11/27 21:36] hc625ma |
simchair4:guide_master_controller_v2 [2021/03/06 10:35] (current) hc625ma |
||
---|---|---|---|
Line 22: | Line 22: | ||
===== Assembly guide ===== | ===== Assembly guide ===== | ||
- | 1. Insert the Leonardo board into its place in the box, fix with 4 3x6mm screws. Snap off the Micro-USB socket, remove the power input socket and solder the USB-B one as shown in the picture below: | + | 1. Insert the Leonardo board into its place in the box, fix with 4 3x6mm screws. Snap off the Micro-USB socket, remove the power input socket and solder the USB-B one as shown in the picture below (you can use the Pro Micro board alternatively, |
+ | |||
+ | {{http:// | ||
+ | {{http:// | ||
+ | {{http:// | ||
- | {{http:// | ||
- | {{http:// | ||
WARNING! We will be using cable joints to connect wires of the I2C cable. Make sure only 1 wire from | WARNING! We will be using cable joints to connect wires of the I2C cable. Make sure only 1 wire from | ||
Line 48: | Line 50: | ||
RST -> PBS-10-B2 | RST -> PBS-10-B2 | ||
| | ||
- | Time to test the controller in both modes. Look at the "How to use the controller" | + | Time to test the controller in both modes. Look at the "How to use the controller" |
| | ||
{{http:// | {{http:// | ||
Line 61: | Line 63: | ||
* F (FLY) - the main mode used for operation and flashing of the master controller. | * F (FLY) - the main mode used for operation and flashing of the master controller. | ||
* P (PROGRAM) - the mode, used for flashing peripherals. | * P (PROGRAM) - the mode, used for flashing peripherals. | ||
+ | |||
+ | To flash the **master controller firmware**: | ||
+ | 1. Check that the mode switch is in the " | ||
+ | 2. Install libraries from z_libraries folder (copy them to Arduino/ | ||
+ | 3. Open the master firmware and select your hardware on the device definitions tab | ||
+ | 4. Select the COM port with " | ||
+ | 5. Select " | ||
+ | 6. Press " | ||
+ | 7. That's it! After " | ||
+ | | ||
To use the controller for **flashing of your peripheral**: | To use the controller for **flashing of your peripheral**: | ||
Line 66: | Line 78: | ||
1. Connect the peripheral to the separated port of the controller | 1. Connect the peripheral to the separated port of the controller | ||
2. Set the mode switch to " | 2. Set the mode switch to " | ||
- | 3. Press the R (RST) button\ | + | 3. Press the R (RST) button |
4. Open the firmware file for your peripheral | 4. Open the firmware file for your peripheral | ||
5. Select the COM port with " | 5. Select the COM port with " |