This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
simchair4:guide_master_controller_v2 [2020/11/27 22:20] hc625ma |
simchair4:guide_master_controller_v2 [2021/03/06 10:35] (current) hc625ma |
||
---|---|---|---|
Line 22: | Line 22: | ||
===== Assembly guide ===== | ===== Assembly guide ===== | ||
- | 1. Insert the Leonardo board into its place in the box, fix with 4 3x6mm screws. Snap off the Micro-USB socket, remove the power input socket and solder the USB-B one as shown in the picture below: | + | 1. Insert the Leonardo board into its place in the box, fix with 4 3x6mm screws. Snap off the Micro-USB socket, remove the power input socket and solder the USB-B one as shown in the picture below (you can use the Pro Micro board alternatively, |
+ | |||
+ | {{http:// | ||
+ | {{http:// | ||
+ | {{http:// | ||
- | {{http:// | ||
- | {{http:// | ||
WARNING! We will be using cable joints to connect wires of the I2C cable. Make sure only 1 wire from | WARNING! We will be using cable joints to connect wires of the I2C cable. Make sure only 1 wire from | ||
Line 63: | Line 65: | ||
To flash the **master controller firmware**: | To flash the **master controller firmware**: | ||
- | 1. Connect the master to your PC | + | 1. Check that the mode switch |
- | 2. Set the mode switch | + | |
- | 3. Press the R (RST) button | + | |
- | | + | |
- | | + | |
- | | + | |
- | | + | |
- | | + | |
- | | + | |
| | ||