This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
simchair4:guide_master_controller_v2 [2020/11/27 22:21] hc625ma |
simchair4:guide_master_controller_v2 [2021/03/06 10:35] (current) hc625ma |
||
---|---|---|---|
Line 22: | Line 22: | ||
===== Assembly guide ===== | ===== Assembly guide ===== | ||
- | 1. Insert the Leonardo board into its place in the box, fix with 4 3x6mm screws. Snap off the Micro-USB socket, remove the power input socket and solder the USB-B one as shown in the picture below: | + | 1. Insert the Leonardo board into its place in the box, fix with 4 3x6mm screws. Snap off the Micro-USB socket, remove the power input socket and solder the USB-B one as shown in the picture below (you can use the Pro Micro board alternatively, |
+ | |||
+ | {{http:// | ||
+ | {{http:// | ||
+ | {{http:// | ||
- | {{http:// | ||
- | {{http:// | ||
WARNING! We will be using cable joints to connect wires of the I2C cable. Make sure only 1 wire from | WARNING! We will be using cable joints to connect wires of the I2C cable. Make sure only 1 wire from | ||
Line 67: | Line 69: | ||
3. Open the master firmware and select your hardware on the device definitions tab | 3. Open the master firmware and select your hardware on the device definitions tab | ||
4. Select the COM port with " | 4. Select the COM port with " | ||
- | 5. Select " | + | 5. Select " |
6. Press " | 6. Press " | ||
7. That's it! After " | 7. That's it! After " |