Differences

This shows you the differences between two versions of the page.

--- simchair4:guide_sens_control_panel [2019/09/24 23:07]
retrogamer [Assembly Guide]
+++ simchair4:guide_sens_control_panel [2020/02/08 19:41]
hc625ma
@@ Line 5: / Line 5: @@
 ====Summary====
-This panel allows you to set sensitivity (rates) of your cyclic and pedals precisely, in a linear way: Make adjustments with the knobs, until your physical stick/pedals movements will roughly correspond to the on-screen ones, or in the way that you find most comfortable.
+This panel allows you to set the sensitivity (rates) of your cyclic and pedals precisely, in a linear way: Make adjustments with the knobs, until your physical stick/pedals movements will roughly correspond to the on-screen ones, or in the way that you find most comfortable.
 The default sensitivity values are set in the software, from bottom-left mark:
@@ Line 35: / Line 35: @@
 Wire the pots in the following way:
+{{:simchair4:img_20200208_212039.jpg?direct&600|}}
   ETHERNET WHITE-ORANGE -> POT 1 & 2 VCC
@@ Line 40: / Line 42: @@
   ETHERNET WHITE-GREEN  -> POT 1 SIGNAL
   ETHERNET BLUE         -> POT 2 SIGNAL
+Fix the cable with hot glue as shown in the picture above.
 This panel connects to the RATES (FORMER FTCR) port, located on the cyclic base. The port is wired in the following way:

Simchair MKIV wiki