Differences

This shows you the differences between two versions of the page.

--- simchair4:guide_sens_control_panel [2019/09/24 22:11]
hc625ma
+++ simchair4:guide_sens_control_panel [2020/02/08 19:42] (current)
hc625ma
@@ Line 5: / Line 5: @@
 ====Summary====
-This panel allows you to precisely set sensitivity (rates) of your cyclic and pedals in a linear way. Adjust knobs until your physical stick movements will roughly correspond those of the on-screen one, or in the way you find comfortable.
+This panel allows you to set the sensitivity (rates) of your cyclic and pedals precisely, in a linear way: Make adjustments with the knobs, until your physical stick/pedals movements will roughly correspond to the on-screen ones, or in the way that you find most comfortable.
-Default sensitivity values set in software, from bottom-left mark:
+The default sensitivity values are set in the software, from bottom-left mark:
   MARK   SENS
@@ Line 25: / Line 25: @@
   * 2 x 16K1 linear 10K pots
   * 2 x M3 nuts
-  * 1 x ethernet cable
+  * 1 x Ethernet cable
   * 4 x M3x12 screws
-  * 2 x M3x30 screws
+  * 2 x M3x40 screws
 ==== Repository path ====
-V:\simchair4\simchair4_models\printable components\peripherals\helicopter\cyclic lever\d_sens_control_panel - models
+simchair4_models\printable components\peripherals\helicopter\cyclic lever\d_sens_control_panel - models
 ==== Assembly Guide ====
-Wire pots in the following way:
+Wire the pots as described below and fix the cable with some hot glue:
+{{:simchair4:img_20200208_212039.jpg?direct&600|}}
   ETHERNET WHITE-ORANGE -> POT 1 & 2 VCC
@@ Line 41: / Line 43: @@
   ETHERNET BLUE         -> POT 2 SIGNAL
-This panel connects to the RATES (FORMER FTCR) port on the cyclic base. The port is wired in the following way:
+This panel connects to the RATES (FORMER FTCR) port, located on the cyclic base. The port is wired in the following way:
   SOCKET PIN 1 -> VCC

Simchair MKIV wiki

User Tools

Site Tools

Differences

Page Tools