This is an old revision of the document!
This panel allows you to precisely set sensitivity (rates) of your cyclic and pedals in a linear way. Adjust knobs until your physical stick movements will roughly correspond those of the on-screen one, or in the way you find comfortable.
Default sensitivity values set in software, from bottom-left mark:
MARK SENS 1 80 2 85 3 90 4 95 5 100 (MARKED WHITE) 6 105 7 110 8 115 9 120 10 125
simchair4_models\printable components\peripherals\helicopter\cyclic lever\d_sens_control_panel - models
Wire pots in the following way:
ETHERNET WHITE-ORANGE -> POT 1 & 2 VCC ETHERNET ORANGE -> POT 1 & 2 GND ETHERNET WHITE-GREEN -> POT 1 SIGNAL ETHERNET BLUE -> POT 2 SIGNAL
This panel connects to the RATES (FORMER FTCR) port on the cyclic base. The port is wired in the following way:
SOCKET PIN 1 -> VCC SOCKET PIN 2 -> GND SOCKET PIN 3 -> ADS1115 A2 SOCKET PIN 4 -> ADS1115 A3