This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
simchair4:guide_sens_control_panel [2019/09/24 22:13] hc625ma [Components] |
simchair4:guide_sens_control_panel [2020/02/08 19:42] (current) hc625ma |
||
---|---|---|---|
Line 5: | Line 5: | ||
====Summary==== | ====Summary==== | ||
- | This panel allows you to precisely | + | This panel allows you to set the sensitivity (rates) of your cyclic and pedals |
- | Default | + | The default |
MARK SENS | MARK SENS | ||
Line 25: | Line 25: | ||
* 2 x 16K1 linear 10K pots | * 2 x 16K1 linear 10K pots | ||
* 2 x M3 nuts | * 2 x M3 nuts | ||
- | * 1 x ethernet | + | * 1 x Ethernet |
* 4 x M3x12 screws | * 4 x M3x12 screws | ||
* 2 x M3x40 screws | * 2 x M3x40 screws | ||
Line 34: | Line 34: | ||
==== Assembly Guide ==== | ==== Assembly Guide ==== | ||
- | Wire pots in the following way: | + | Wire the pots as described below and fix the cable with some hot glue: |
+ | |||
+ | {{: | ||
ETHERNET WHITE-ORANGE -> POT 1 & 2 VCC | ETHERNET WHITE-ORANGE -> POT 1 & 2 VCC | ||
Line 41: | Line 43: | ||
ETHERNET BLUE -> POT 2 SIGNAL | ETHERNET BLUE -> POT 2 SIGNAL | ||
| | ||
- | This panel connects to the RATES (FORMER FTCR) port on the cyclic base. The port is wired in the following way: | + | |
+ | This panel connects to the RATES (FORMER FTCR) port, located | ||
SOCKET PIN 1 -> VCC | SOCKET PIN 1 -> VCC |