This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
simchair4:guide_sens_control_panel [2019/09/24 23:07] retrogamer [Assembly Guide] |
simchair4:guide_sens_control_panel [2020/02/08 19:42] (current) hc625ma |
||
---|---|---|---|
Line 5: | Line 5: | ||
====Summary==== | ====Summary==== | ||
- | This panel allows you to set sensitivity (rates) of your cyclic and pedals precisely, in a linear way: Make adjustments with the knobs, until your physical stick/ | + | This panel allows you to set the sensitivity (rates) of your cyclic and pedals precisely, in a linear way: Make adjustments with the knobs, until your physical stick/ |
The default sensitivity values are set in the software, from bottom-left mark: | The default sensitivity values are set in the software, from bottom-left mark: | ||
Line 34: | Line 34: | ||
==== Assembly Guide ==== | ==== Assembly Guide ==== | ||
- | Wire the pots in the following way: | + | Wire the pots as described below and fix the cable with some hot glue: |
+ | |||
+ | {{: | ||
ETHERNET WHITE-ORANGE -> POT 1 & 2 VCC | ETHERNET WHITE-ORANGE -> POT 1 & 2 VCC | ||
Line 40: | Line 42: | ||
ETHERNET WHITE-GREEN | ETHERNET WHITE-GREEN | ||
ETHERNET BLUE -> POT 2 SIGNAL | ETHERNET BLUE -> POT 2 SIGNAL | ||
+ | | ||
| | ||
This panel connects to the RATES (FORMER FTCR) port, located on the cyclic base. The port is wired in the following way: | This panel connects to the RATES (FORMER FTCR) port, located on the cyclic base. The port is wired in the following way: |