This is an old revision of the document!
This panel allows you to set the sensitivity (rates) of your cyclic and pedals precisely, in a linear way: Make adjustments with the knobs, until your physical stick/pedals movements will roughly correspond to the on-screen ones, or in the way that you find most comfortable.
The default sensitivity values are set in the software, from bottom-left mark:
MARK SENS 1 80 2 85 3 90 4 95 5 100 (MARKED WHITE) 6 105 7 110 8 115 9 120 10 125
simchair4_models\printable components\peripherals\helicopter\cyclic lever\d_sens_control_panel - models
Wire the pots in the following way:
ETHERNET WHITE-ORANGE -> POT 1 & 2 VCC ETHERNET ORANGE -> POT 1 & 2 GND ETHERNET WHITE-GREEN -> POT 1 SIGNAL ETHERNET BLUE -> POT 2 SIGNAL
Fix the cable with hot glue as shown in the picture above.
This panel connects to the RATES (FORMER FTCR) port, located on the cyclic base. The port is wired in the following way:
SOCKET PIN 1 -> VCC SOCKET PIN 2 -> GND SOCKET PIN 3 -> ADS1115 A2 SOCKET PIN 4 -> ADS1115 A3