4 Replies to “Huey collective head manual reworked!”

  1. Hi, I am fascinated with this project. So I have started building a UH-1 Huey collective. I am a noob, most definately. I have followed your detailed manual, but I am having trouble connecting some wires which result in an arduino not recognised by my pc.
    Could you post a connection sheme/drawing of each wire in the head so i can check where I would have made a mistake?
    Thank you for such a fantastic project.

    1. hi! please join simchair DIY discord server: https://discord.gg/4fvCutyP

      Arduino should be recognized when you plug it in, but in the head, the one without USB is used, which communicates with the master controller through an I2C connection. Do you mean the master controller is not recognized? Or do you mean the USB-UART driver is not recognized?

      1. Hi, thank you for your kind reply. For the moment I have only constructed the huey head. So when I connect the completed head to my pc, the lights on the arduino light up but there is no connection. When I try to upload the software it does not recognise the arduino board. I have read that not all pins may be connected, if I remember correctly RXI , for the arduino to be recognized? I am a fossile when it comes to new communication methods, so I will try discord out. Thank you very much.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.